AIR GAP Fluidmaster 6000 Series Installation Manual Download Page 5

Page: 5 / 8

Washer

6000 Series AirGap™ Installation Guide

Preparing for installation

Step 4

Most tank fed systems (<7m of
vertical pipe) will benefit from the
removal of the

flow controller and

filter.

Mains water or pumped

installations require the filter/restrictor
to be fitted.

Note:

For side entry valve, ensure the

flow

controller and filter

is fitted in the

orientation as shown.

Step 5

Check that the sealing

washer

pushed fully onto the

threaded shank.

Summary of Contents for Fluidmaster 6000 Series

Page 1: ...ation Guide Bottom entry valve assembly Float adjustment screw 1 Cap 2 Anti siphon vortex generator 3 Float chamber locking sleeve 4 Washer 5 1 2 or 3 8 BSP threaded shank 6 Nut 7 Pre fitted flow controller and filter 8 INSTALL WITH CONFIDENCE ...

Page 2: ...Series AirGap Installation Guide Side entry valve assembly Float adjustment screw 1 Cap 2 Anti siphon vortex generator 3 Float chamber 4 Washer 5 1 2 or 3 8 BSP threaded shank 6 Nut 7 Pre fitted flow controller and filter 8 ...

Page 4: ... your cistern Drain all water from the cistern and disconnect valve supply pipework Step 3 Remove the old valve from the cistern and ensure the fixing hole area is clean and free of debris or anything which may impair sealing Step 1 Turn off the water supply to the toilet using isolation valve or mains stopcock ...

Page 5: ... will benefit from the removal of the flow controller and filter Mains water or pumped installations require the filter restrictor to be fitted Note For side entry valve ensure the flow controller and filter is fitted in the orientation as shown Step 5 Check that the sealing washer is pushed fully onto the threaded shank ...