19/04/2019
V2.0
Page
5
of
24
2. Preparing the paramotor
2.1 Package content
The complete standard version of your Air Conception paramotor includes the following
items:
1.
Frame with engine and harness
1 pc.
2.
Propeller cage
1 set
3.
Propeller
1 pc.
4.
Propeller mounting screws
1 set
5.
Optional cage bag & prop covers
1 set
6.
Two batteries with one charger (e-start version only)
1 set
7.
User’s manual on USB key or online link for download 1 pc.
The serial number of the propeller is on the inner surface of its hub and is visible when
separated from the paramotor.
The serial number of the engine is stamped on the casing.
2.2 First time paramotor assembly
2.2.1 Mounting of the propeller
The propeller is mounted with six M6 screws steel or titanium depending on model with
washers. The set of propeller mounting screws with the red aluminum washer (propeller
screw plate) can be found in the side pocket of the harness or in the a cage bag pocket.
Propeller mounting screws must be screwed cross-wide in two stages: first – using 6 Nm
torque – then you should check blade axial wobbling. The difference between the trail of
both tips of the blade should not exceed 8mm. In second stage, screws must be tightened
using 10 Nm torque. If the difference of the trail exceeds 8mm you should loosen the screws
and then tighten them cross-pattern once again but this time using bigger torque on the
side of the blade that sticks out more from the engine. You should not use any washers
under the propeller because they can break off the screws that hold the propeller during the
flight.
For mounting of the propeller use allen key 5. Tools are not included in the package.
You should not tighten the screws that hold the propeller by using torque bigger than
10 Nm.
