AIPTEK V5Z25, Manual

Page: 5 / 248

To insert a memory card, do the followings:
(1) Press the Push button first and slide the battery compartment
cover.
(2) Gently push the card until the card reaches the bottom of the
slot.
To remove the memory card, gently push the card and it will pop
up. Then pull the card out of the slot.
Inserting a memory card (optional)
Please charge the battery at least 8 hours for first time use. Afterwards, it will take
approximately 3 hours to fully charge the battery by AC adapter.
1. Connect the cable.
Connect one end of the supplied AC adapter to the USB port of the
camcorder and the other end to a wall outlet.
OR
Connect one end of the supplied USB cable to the USB port of
the camcorder and the other end to a powered PC. Make sure the
camcorder is powered off.
2. The charging LED turns red and the charge starts.
3. When the charging is interrupted or the battery pack is fully charged, the charging LED
will turn green.
When using a PC to charge the battery, do not power on the camcorder, or
the charge will stop.
Installing the battery
1. Press the Push button first and slide the battery compartment
cover.
2. Place the accessory Li-Ion battery into the compartment until it is
locked by the latch. Note that the metallic contacts must be aligned
with the contacts in the compartment.
3. After the battery is properly installed, close the battery
compartment cover.
Charging the battery
Open the LCD monitor or press and hold down the Power button for 1 second to turn on
the camcorder.
To turn off the camcorder, press and hold down the Power button for 1 ~ 3 seconds or
close the LCD monitor.
Turning on/off your camcorder
If the camcorder stays inactive for a long period of time, it may automatically
shut down due to the Auto-Off setting.