Aimco SPC-P21225Q, Instruction Manual

Page: 6 / 20

6
● Do not incinerate the battery
pack even if it is severely dam-
aged or completely worn out.
The battery pack can explode in
a fire.
● Be careful not to drop, shake, or
strike the battery.
● Do not charge inside a box or
container of any kind. The bat-
tery must be placed in a well-
ventilated area during charging.
● Do not dispose of battery packs
into household waste, fire, or
water. Battery packs should be
collected, recycled, or disposed
of in an environmentally-friendly
manner. Call authorized warran-
ty centers for locations to dis-
pose of damaged or inoperable
batteries.
The Signature Series Precision
Clutch industrial shut off screwdriver
is designed for nut tightening/
loosening
and screw driving/
loosening. It is not appropriate to
use for wood/mild steel drilling.
Please refer to Figure 1 on this
page to familiarize yourself with the
major components of this tool be-
fore use.
1. Power Switch
Depressing the power switch will
energize the LED light (2) in front
and the tool starts to rotate. When
released, power to the motor ceas-
es and the tool stops working im-
mediately. The LED light will re-
main on for 5 seconds, then shut
off.
2. LED Light
3. Forward/Reverse Button
The tool is always in forward
operation unless the Forward/
Reverse button is pressed.
When the button is pressed, the
Functional Description
blue LED shows and the tool will
be in reverse operation. To
switch the tool back to forward
operation, simply press the but-
ton again. The blue LED shuts
off and the tool is back in for-
ward operation.
4. Quick Change Holder
This driver accepts only 1/4” hex
bits. Be sure the bit is fully en-
gaged by the chuck before oper-
ating tool. Otherwise, the bit may
detach and cause property dam-
age or personal injury.
5. Li-Ion Battery
This battery provides electrical
power to the motor. Please
charge it according to the charg-
ing instruction listed in this man-
ual.
6. Torque Adjustment Cover
Open the torque adjustment cap.
Use the supplied torque adjust-
ment tool to either tighten or loos-
en the spring until the desired
torque is reached. CW increases
torque output, CCW decreases
torque output. Page 8 describes
this in detail.
WARNING: Use the tool to either
tighten or loosen nuts and screws
ONLY in stipulated torque and volt-
age ranges.
4
6
3
2
1
5
Figure 1