2
MultiChron
MultiChron
One driver timing
Pause
Recall recorded data
Best time/Total time
Clear data
Change MultiChron configuration
If you are timing one only driver, the best mode is the MultiChron default mode, Multi Start /
Multi Key. The timer is ready to use immediately without any configuration. You can use
“Start/Lap” and “Reset/Split” button to record Lap and Split times.
Press “STOP/SEL” button for about two seconds.
(both during the race and after)
Press “RECALL” to show the most recent times for each driver.
Use buttons “1” (-) and “2” (+) to scroll only lap times and buttons “3” (-) and “4” (+) to scroll all
times (lap by lap including split times).
Press “RECALL” button again to leave recall mode.
(both during the race and after)
Press “BEST” to show the best lap times of running drivers.
Press ”BEST” 2 times to show total times (adding of all times) for running drivers.
Press “BEST” a third time to switch back to the main page.
(with the chronometer stopped)
Stop the chronometer (STOP/SEL) and press the “RESET/SPLIT” button for about two seconds.
(with the chronometer off)
Press “CONF” button and use “STOP/SEL” button to switch from “KEY” option setting to “START”
option setting and buttons “3/-“ and “4/+” to switch from “Multi” to “One” and vice versa.
Start modes: One Start and Multi Start
Lap and Split recording modes: One Key and Multi Key
One Start
: allows you to activate the start for the four drivers by pressing one button, typically
used to time a race where all drivers start at the same time.
Multi Start
: allows you to activate the timer for each driver independently, in case drivers start at
different times.
Multi key
: links one button to one driver. To record lap times of the four drivers press one of the
four numeric buttons (from 1 to 4); button 1 duplicates the START/LAP button. To record split
times press the SPLIT button together with one of the four buttons 1-4. Pressing SPLIT button
without pressing one of the four numerical buttons (1-4) records the first driver split time.
One key
: links one button (LAP or SPLIT) to all drivers. By pressing it, all rows related to times start
blinking and continue until you specify which driver by pressing one of the numerical buttons (1-
4) for that driver. This mode is useful when, for example, all the drivers pass within a few seconds
on Start/Finish Line: it is easier and more accurate to press the single LAP button each time a
driver passes, and link later the recorded times to the different drivers. If for instance drivers 3, 1
and 2 pass by in that order, you can record their times by pressing LAP three times (each time a
driver passes) and then press buttons 3, 1 and 2.
MultiChron timing modes
Hand-held digital stopwatch
Hand-held digital stopwatch
