4. RGB LED
EVO5 features an RGB LED on top of it near
to the SD Card slot.
The LED shows the logger status as for the
following table:
CHAPTER 4 RGB LED
CHAPTER 5 ECU CONNECTION
10
11
EVO5
LOGGER STATUS
Doing firmup
Logger in error
Recording
WiFi connected
WiFi available (but not connected)
Idle status
(WiFi off+EVO5 not recording)
The ECU has to be set when configuring
your system with RS3 configuration soft-
ware.
The steps are explained in the related sec-
tion.
CAN Resistors
EVO5 features two 120 Ohm ending
resistors on CAN1 and CAN2 Line whose
status by default is:
n
Enabled on CAN1
n
Disabled on CAN2
5. ECU connection and CAN resistors
The system can acquire data from the ECU
of your vehicle. The list of the available ECU
protocols is published on our site:
www.aim-sportline.com/download area,
ECU connections.
This list includes approximately more than
1000 different protocols and is constantly
updated with new protocols.
When possible documents explaining how
to configure your ECU to ensure compati-
bility between the data flow transmitted
are available, too.
From an hardware point of view, the system
is compatible with all currently available
connections: CAN, RS232 or K Line.
The steps to manage the data coming from
the ECU are the following:
1. Determine wich hardware connection is
available for your ECU
2. Read the documentation about your ECU
at www.aim-sportline.com and identify the
name of the software driver to be specified
3. Using Race Studio 3, configure EVO5 set-
ting your ECU driver with the menu shown
here below, that appears when you create
a new configuration.
LED COLOUR
BLINKING
Blue
Quickly
Red
Slowly
Cyan
Still
Yellow
Still
White
Still
Green
Still