4. RGB Led
The led shows the logger status as for the
following table:
CHAPTER 4 RGB LED
CHAPTER 5 ECU CONNECTION
10
11
EVO4S
LOGGER STATUS
Doing firmup
Logger in error
Recording
Idle status (EVO4S not recording)
The ECU has to be set when configuring
your EVO4S with RS3 configuration
software.
The steps are explained in section 10.1.2
CAN Resistors
EVO4S features a 120 Ohm ending
resistor on CAN Line whose status by
default is enabled.
5. ECU connection and CAN resistors
EVO5 can acquire data from the ECU
of your vehicle. The list of the available
ECU protocols is published on our site:
www.aim-sportline.com/download area,
ecus connections.
This list includes approximately 500
different protocols and is constantly
updated with new protocols and upgrades
published every week.
When possible, documents explaining how
to configure your ECU to ensure
compatibility between the data flow
transmitted are available, too.
From an hardware point of view, EVO4S is
compatible with all currently available
connections: CAN, RS232 or K line.
The steps to manage the data coming from
the ECU are the following:
1. Determine wich hardware connection is
available for your ECU
2. Read the documentation about your ECU
at www.aim-sportline.com and identify the
name of the software driver to be specified
3. Using RaceStudio3, configure EVO4S set-
ting your ECU driver with the menu shown
here below, that appears when you create
a new configuration.
LED COLOUR
BLINKING
Blue Quickly
Red Slowly
Cyan Still
Green Still
RGB LED
EVO4S.qxp_Layout 1 09/01/17 10:21 Pagina 11