ECU Bridge
User Manual
Release 1.08
www.aim-sportline.com
14
1 9
3.2.3 – Learning lap
During the
learning lap
follow carefully these instructions:
•
start driving ensuring that the street is clear;
•
engage all gears in sequence;
•
keep each gear engaged for at least 5/6 seconds;
•
drive in a “smooth” way avoiding sudden accelerations, slips or wheel blocks
in braking; RPM should increase gradually;
•
engage all gears and switch of the vehicle or
ECU Bridge
once the last gear
reached; if this is not possible shift the gears each 5/6 seconds engaging the
clutch for the minimum time.
Warning: absolutely avoid “revs” while the vehicle is moving and do not drive with
the clutch pedal pressed. If required by the vehicle press the accelerator before
switching off the engine but only with the vehicle is completely stopped.
1 7
3.2.4 – Erasing gear calibration
To clear gear calibration use
Race Studio 2
software. The procedure is the same
performed to set calculated gears but in spite of “Calculated” highlighted by “4” in the
previous image, set “
None
” and transmit the configuration to
ECU Bridge
.
To re-compute the engaged gear select again
Calculated
option and transmit the
configuration:
ECU Bridge
is again ready for a new calibration.
8
3.3 – Configuring the displays
To see data sampled by
ECU Bridge
it is possible to connect it to an
AIM
display.
Available displays are
MyChron3 Dash
,
Formula Steering wheel
and
TG Dash
.
Information shown on the different display pages are set through
Race Studio 2
.
Refer to Race Studio Configuration user manual to know how to configure ECU
Bridge and/or the displays and to the display user manual for further information
concerning their working mode.
9
3.4 – Maintenance
The only recommended maintenance for
ECU Bridge
is a periodical software/firmware
update. Updates are downloadable from
Download area firmware/software.
To update firmware/software:
•
connect
ECU Bridge
,
SmartyCam
and its external GPS;
•
;
•
click “Firmware” or “Software” in Home Page;
•
check if any update has been released;
•
download and run them double clicking on;
•
follow the instruction that appears on the PC monitor.
