GB
1. Slide the power switch on left side to turn on/off the clipper.
2. Mount and adjust the comb attachment to the required setting.
1.Cut hair by placing the clipper head directly on the scalp.
2.Use the adjustable lever to adjust cutting height and edge. (See
Maintenance --Adjustable lever.)
1.Operating current not exceeding 30mA is advisable in the electrical circuit
supplying the bathroom. Ask your installer for advice.
3. Cut hair to the correct height by moving the clipper back against the flow
of the hair.
4. Turn off the appliance and remove the comb attachment.
BEFORE FIRST USE
OPERATION
MAINTENANCE AND CLEANING
1. Before using each time, make sure your clipper is clean, properly oiled and
in perfect working condition. Make sure there is no damage to the blade.
Specifications and design are subject to change without notice.
TECHNICAL SPECIFICATIONS
Model No.
Power Supply
Power Consumption
320100JVN
220-240V ~ 50/60Hz
15W
① To mount the comb attachment, hold the comb with teeth up, snap it
firmly into the bottom of the clipper blade.
② To adjust the cutting length, turn off the appliance and change the comb
attachments：
Comb attachment#1 --- leaves hair approx. 1/8"(3mm) in length
Comb attachment#2 --- leaves hair approx. 1/4"(6mm) in length
Comb attachment#3 --- leaves hair approx. 3/8" (9mm) in length
Comb attachment#4 --- leaves hair approx. 1/2" (12mm) in length
TRIMMING WITHOUT A COMB ATTACHMENT
CUTTING HAIR WITH THE COMB ATTACHMENTS（FIG.B）
MAINTENANCE
07
