Attention: Installations should be performed by qualified service
personnel only in accordance with the National Electrical Code or
applicable local codes.
10
5.2 Mounting
See Figure 1.
1.
Using the rubber base gasket as a template, mark the mounting hole
locations on the mounting surface.The unit is intended to be mounted
with four #10 screws or four M5 screws (not supplied) through the four
outer holes in the base plate.
Cable
AC24
RED
~
BLACK
WHITE
~
GND
YELLOW COLOR
PURPLE B/W
POWER CABLE
DAY/NIGHT
CABLE
5
INSTALLATION
Figure 2 Power Cable/Day-Night Cable
Caution: Before proceeding to disconnect the power at its
source, be sure that the unit is of the proper voltage type for the
line power.
5.1 Connecting Low Voltage Power & Video Signal
The wiring harness has a BNC connector to accept video coax and two
stripped leads to accept the low voltage power. For mounting to a single gang
electrical box, run power and video lines through a knockout into the box
(not provided).When mounting directly to a wall or ceiling, run power and
video lines to the desired location using conduit.
5.1.1 Connecting Low Voltage Power
Connect the line and neutral wires. See Figure 2
1.
24 VAC Applications: Camera operation is not affected by the polarity of
the 24 VAC wires. However, in multiple camera systems, consistent wiring
configurations will help maintain roll-free switching.
5.1.2 Connecting Video Cable
Route and connect video cable to BNC connector.
