5.8
Power Connection
5.8.1 Power Connection
HS9383S
1.
Pull the wires through the conduit fitting and make sure
that the threaded section of the fitting mates up with the
threads in the rear cap.
2.
Pull the wires through the threaded hole in the rear cap
of the cradle.
3.
A screw, nut and terminal lug are provided for the safety
ground.
4.
Unscrew the terminal lug and attach the ground wire.
Attach the lug back to the rail of the cradle.
5.
Connect the power wires to the camera per instructions
provided with the camera.
5
Spacer
Washer
1/4 - 20 Screw
Spacer
Washer
1/4 - 20 Screw
Figure 3: Mounting a Fixed Lens Camera
Figure 4: Mounting a Zoom Lens Camera
WARNING:
Only use the cables specified under
INSTALLATION, Cable Requirements for wiring of
all cameras and lenses.
Crad
le
Terminal Lug
Threaded Hole
Rear Cap
Cradle Rail
Figure 5: Power Connection
Z
Zo
oo
om
m L
Le
en
nss C
Ca
am
me
erra
ass::
Allow
3
/
16
-inch (5 mm) clearance
from the front face of the lens to the front faceplate of the
cradle during the camera/lens assembly. This clearance
provides the necessary space for the lens to extend
outward when zooming. Secure both the camera and the
lens to the cradle with the
1
4
-20 BHCS and appropriate
plastic spacer. See
Figure 4.
5.8.2 Power Connection
HS9383-2H
1.
Pull the wires through the conduit fitting and make sure
that the threaded section of the fitting mates up with the
threads in the rear cap.
2.
Pull the power wires through the threaded hole in the
rear cap of the cradle.
3.
A screw, nut and terminal lug are provided for the safety
ground. See
Figure 5
.
5.7
Video Cable Connection
1. Pull the video cable through the conduit fitting and make
sure that the threaded section of the fitting mates up
with the threads on the rear cap.
2. Pull the video cable through the threaded hole in the rear
cap of the cradle.
3. Connect the video cable to the camera.
4. If using a zoom lens, pull the lens cable through the
conduit fitting and attach to the zoom lens pursuant to
the manual supplied with that product.
4.
Unscrew the terminal lug and attach it to the ground
wire. Attach the lug back to the rail of the cradle.
5.
Install the power wires by using the gray connectors
provided. Push and hold the side of the connector that
does not have wires in it. Slide the tip of the wire into
the opening of the connector until it stops then release.
Repeat this same operation for the other connector. See
Figure 5
.
6.
Connect the camera to the black and white wires per the
instructions provided with your camera.
Gray
Connectors
Insert wire
Insert wire
Figure 6: Wire Connectors
