DAC3040
16
5. BEFORE OPERATING
Before using the nailer you should ensure that
The trigger works
The nail type is suitable for the work piece
The right compressed air level and the purity of the air
That the work piece does not move
The working area is well organized in order to avoid reaching when nailing.
The personal safety equipment is sufficient and in good condition.
6. USING THE NAILER
Adjust the pressure to the minimum recommended level.
Remove the machine from the pneumatic network.
Add nails to the machine by following the loading instructions.
Connect the pneumatic hose to the nailer. Make sure that the operating switch is
not pressed when connecting the machine to the pneumatic network.
Test the nailer to wood in order to check if the nail reaches the right depth. If the
nail goes too deep/through the wood, adjust the air pressure. Do not exceed the
advised maximum pressure.
Mark the nailing area beforehand and make sure that the nailing area is clean. Also
make sure that there are no cables, wires or pipes in the nailing area.
Support the work piece on its place to the base.
NOTE!
Do not try to use the nailer if the nail holder is empty.
Always remove the machine from the pneumatic network during breaks and after
use.
If you have doubts about the machine use, please contact the dealer or experienced
technician.
NOTE!
The nailer might kick back if the nail hits a hard material.
The nail might change its direction when hitting a hard material, such as a branch,
piece of steel of another nail.
Always hold the nailer firmly and push the machine against the work piece.
