35
GB
9. Check tire pressure
every
100
working hours
When checking tire pressure or inflating the tire always position yourself
in line with tire tread, not in front of the tire wall. When removing a
wheel from the vehicle always use an inflation cage. Keep all personnel
well away from the area.
Note
: Should the tire be replaced, always make sure that the tread is positioned as it is
shown.
10. Battery
Check that the battery is clean and that
the terminals are properly insulated.
These must always be covered with
grease. Check electrolyte (distilled
water) level and top up if necessary;
the electrolyte should just cover the
electrodes. Should the vehicle remain
idle for a long period, dismantle the
battery and keep it in a dry place.
Dislodge fuel feeding pipe support
(no.2 nuts M8) to remove battery.
(double battery on request)
Battery knife switch
The battery knife switch is located in
the vehicle cab, under the parking brake
lever. If the vehicle is left unguarded,
disconnect the knife switch.
11. Tighten nuts and bolts.
Check all bolt-held connections. (See
tightening torque table).
- 15.5 - 25 (12 pr)
Front 3,5 kg/cm
2
Rear 2,5 kg/cm
2
- 17,5 - 25 (12 pr)
Front 3,5 kg/cm
2
Rear 2,5 kg/cm
2
- 15,5 R 25
Front 2,5 kg/cm
2
Rear 2 kg/cm
2
- 17,5 R 25
Front 2,5 kg/cm
2
Rear 2 kg/cm
2
- 405/80 R25
Front 2,5 kg/cm
2
Rear 2 kg/cm
2
