8) Take the second lamp cord and socket and drape it over the U-bracket on the extender
arm on the side of the center bar with the pink dot. Make sure to leave enough slack in the
cord between the the socket and the U-bracket to enable hanging the reflector at its lowest
point. Zip tie the cord to the U-bracket hardware at the top of the arm.
9) Take the lamp cord and zip tie it to the PINK eye bolt on the motor. The cord MUST pass
on the side of the motor with the BLUE eye bolt–not the other side! Make sure you leave
enough slack in the lamp cord to accommodate proper rotation of
the light mover–about a 6” bow should be sufficient.
10)
Note: mounting chain (not included) is necessary for this step;
for optimum stability we recommend two chains per reflector.
Attach mounting chain onto each side of the U-bracket. Attach
both chains to the reflector and repeat for the other arm of the
mover.
A “third hand” (small, empty, sturdy box) may be
helpful to hang the reflectors since their weight
may over-tilt the arms, potentially damaging the
mover.
yellow
eye
bolt
green
eye bolt
pink eye
bolt
allow enough
slack for
rotation
bar with
the pink
dot
lamp cords and
power cord
going to ballasts
blue eye
bolt on
back side
weight
“third hand”
secured to ceiling
