14
No part of the SHARE GT system must come into contact with detergents, fuel or any other fluid
contained in a motor vehicle. These substances can cause irreparable damage to the system.
Cleaning
To clean SHARE GT use a sponge dampened in water and a mild soap if necessary. Do not apply
solvents or degreasers.
While cleaning, ensure that no water gets inside any part of SHARE GT.
Disposal
In the event of disposal of SHARE GT, the product should be disposed of according to the current
instructions applicable to the treatment of electronic waste and batteries. Therefore, the product
cannot be disposed of as unsorted municipal waste
.
The proper disposal of electronic equipment
will help prevent potential negative consequences for the environment and human health.
The crossed-out wheelie bin symbol that can be found on the product means that, within the
European Union, the product must be subject to a selective collection at the end of its life cycle
(Directive 2002/96/EC)
Product Safety
Do’s and Dont’s
Keep SHARE GT off in situations and places where it is forbidden to use devices similar to SHARE
GT for security reasons.
Do not wear a helmet equipped with the SHARE GT system while charging the battery.
If a problem occurs with obvious anomalous effects (e.g. intense heat, smoke, odour, etc.) the
helmet must be removed immediately. If the system is being charged, immediately stop charging
by disconnecting the power cord.
Do not let the inside of the helmet get wet, both while using SHARE GT and during the charging
process, in order to prevent the infiltration of water from creating dangerous situations. If the
system gets wet, turn it off immediately and remove it from the helmet as soon as possible to let it
air dry.
Installation
Incorrect or improper installation of SHARE GT inside the helmet may alter the safety features of
the helmet creating hazardous conditions. For installation, follow the specific installation
instructions and, in case of doubt, contact your authorised AGV dealer.
Tampering with the helmet and/or the electronic system during the installation of SHARE GT can
alter the characteristics of the helmet itself, which would result in its type-approval becoming null
and void and create potentially hazardous situations.
