AGT 5580/3 GP160, Owner'S Manual

Page: 23 / 33

23
Oil Level Check
1. Check the engine oil level with the engine stopped and in a level position. Remove the oil
filler cap/dipstick and wipe it clean.
2. Insert the oil filler cap/dipstick into the oil filler neck as shown, but do not screw it in, then
remove it to check the oil level.
3. If the oil level is near or below the lower limit mark on the dipstick, fill with the recommended
oil to the upper limit mark (bottom edge of the oil fill hole). Do not overfill.
4. Reinstall the oil filler cap/dipstick.
Running the engine with a low oil level can cause engine damage. This type of damage is not
covered by the Warranty.
Oil Change
Drain the used oil when the engine is warm. Warm oil drains quickly and completely.
1. Place a suitable container below the engine to catch the used oil, then remove the oil filler
cap/dipstick, oil drain plug and washer.
2. Allow the used oil to drain completely, then reinstall the oil drain plug and new washer, and
tighten the oil drain plug securely.
3. Please dispose of used motor oil in a manner that is compatible with the environment.We
suggest you take used oil in a sealed container to your local recycling center or service
station for reclamation. Do not throw it in the trash, pour it on the ground, or pour it down a
drain.
4. With the engine in a level position, fill with the recommended oil to the upper limit mark
(bottom edge of the oil fill hole) on the dipstick.
5. Install the oil filler cap/dipstick and tighten securely.
AIR FILTER
A dirty air cleaner will restrict air flow to the carburetor, reducing engine performance. If you operate the
engine in very dusty areas, clean the air filter more often than specified in the MAINTENANCE
SCHEDULE.
Operating the engine without an air filter, or with a damaged air filter, will allow dirt to enter the
engine, causing rapid engine wear. This type of damage is not covered by the Warranty.