13
NOTE
•
Warm up the engine before adjusting the idling
speed.
CUTTER APPLICATION CHART
•
Replace by a suitable recommended cutting
attachment according to the object to be cut.
•
When replacing blade always be sure to use
products which have been recommended by your
dealer.
WARNING
•
When sharpening, removing, or reattaching the
blade, be sure to wear thick, sturdy gloves and use
only proper tools and equipment to prevent injury.
METAL BLADE USAGE
1. Check the nut to fasten the blade and be sure the
nut has no fault, and no abrasion.
2. Be sure that the blade and the holder have been
fastened according to instruction and the blade
turns smoothly without abnormal noise.
WARNING
•
The rotating parts fastened incorrectly may Cause
serious accident to the operator.
•
Make sure that the blade is not bent, warped,
cracked, broken or damaged.
•
If you find any error to the blade, discard it and
change new one w hic h is recommended by your
dealer.
•
By using the shoulder strap, hang the unit on your
right side. Adjust the strap length so that the cutting
head may become parallel to the ground.
WARNING
•
Make sure t o use shoulder strap and debris guard. If
not , it is vary dangerous w hen you slip or lose your
balance.
CUTTING METHOD
(a) Use the front left side cutting.
(b) Guide the blade from your right to left with it tilted
slightly to your left.
(c) When mowing a wide area, start working from your
left end to avoid interference of cut grass.
(d) The blade may be seized by weeds if the engine
speed is too low, or the blade cuts too deep into
weeds. Adjust the engine speed and cutting depth
according to the condition of object.
WARNING
•
If the grass or other object gets caught in the blade,
or if the unit starts to shake or vibrate, turn off the
engine and check the whole unit. Change the blade
if it has been damaged.
•
Turn off the engine and make sure the blade has
completely stop before checking the blade, and
removing any object got caught in.
