11
OPERATION
FUELING THE UNIT
1.
Untwist and remove the fuel cap. Rest the cap on a
dustless place.
2.
Put fuel into the fuel tank to 80% of the full capacity.
3. Fasten the fuel cap securely and wipe up any fuel
spillage around the unit.
WARNING
1.
Select bare ground for fueling.
2. Move at least 10 feet (3 meters) away from the
fueling point before starting the engine.
3. Stop the engine before refueling the unit. At that
time, be sure to sufficiently agitate the mixed
gasoline in the container.
FOR YOUR ENGINE LIFE, AVOID
1.
FUEL WITH NO OIL (RAW GASOLINE) – It will cause
severe damage to the internal engine parts very
quickly.
2. GASOHOL – It can cause deterioration of rubber
and/or plastic parts and disruption of engine
lubrication.
3. OIL FOR 4-CYCLE ENGINE USE – It can cause spark
plug fouling, exhaust port blocking, or piston ring
sticking.
4.
Mixed fuels which have been left unused for
a period of one month or more may clog the
carburetor and result in the engine failing to
operate properly.
5. In the case of storing the product for a long period
of time, clean the fuel tank after rendering it empty.
Next, activate the engine and empty the carburetor
of the composite fuel.
6.
In the case of scrapping the used mixed oil container,
scrap it only at an authorized repository site.
NOTE
•
As for details of quality assurance, read the
description in the section Limited Warranty
carefully. Moreover, normal wear and change in
product with no functional influence are not covered
by the warranty. Also, be careful that, if the usage
in the instruction manual is not observed as to the
mixed gasoline, etc. described therein, it may not be
covered by the warranty.
STARTING ENGINE
WARNING
The cutting head will start rotating upon the engine
starts.
1. Feed fuel into the fuel tank and tighten the cap
securely.
2. Rest the unit on a flat, firm place. Keep the
cuttinghead off the ground and clear of surrounding
objects, as it will start rotating upon starting of the
engine.
3. Push the primer pump several times until
overflownfuel flows out in the clear tube.
4.
Move the choke lever to the closed position.
(1)
(2)
(3)
(1) choke lever
(2) close
(3) open
5. Set the ignition switch to the “I” position. Set the
throttle lever to the half-throttle position (1 2 3).
Place the unit on a flat, firm place. Keep the cutting
head clear of everything around it.
START
Stop
Start
3. Half-throttle lock
1
2
