Agriframes, Journal house, Hartcliffe Way, Bristol, BS3 5RJ
Order line: 01179341790, Fax: 01179341791
Orderon-line:www.agriframes.co.uk
Move the Top section to the intended location…
13. Move the Gazebo top to where the structure will be installed and firmly
push the structure into the ground to make an impression or mark in
The ground. These impressions indicate where the uprights need to be
inserted.
14. Remove the Gazebo top, using the Hole Maker create holes15”deep,
Where you have marked the ground. Ensure the holes are vertical and
to the same depth.
Insert the Uprights…
15. Tap an end plug into the non-reduced end of the84”uprights.
16. Insert an upright into the holes, ensure that the uprights stand vertical
and are level to one another.
17. Attach2spacerbarstoeachof the uprights. The lower spacer bar
shouldbepositioned12”abovegroundlevel, then position the other
Spacer bar50”abovethelowerspacer bar, as shown in Figure 6.
18. Slide a moisture seal onto the reduced end of the upright.
Lift the Top of the Gazebo onto the uprights…
19. Lift the constructed Gazebo Top onto the uprights, ensure that the Gazebo
Top is lowered evenly onto the uprights.
20. Cover the Joins with moisture seals.
Final checks…
21. Check that all of the joins have been covered by moisture seals.
22. Ensure that all of the connectors have been tightened and are fully secured.
12”
Figure6: Position of the
Spacer Bars
Optional Component: Fixing the Bottom Lattice Section…
23. Take the lattice panels and the Lattice Ties.
24. Secure the 5x4 lattice panels between the spacer bars on the top section of the Gazebo, using the
lattice ties.
25. Secure the 5x4 lattice panels between the spacer bars on the uprights of the Gazebo, using the
Lattice ties.
Ensure that the panels are centered within each bay.
please Note: you may need to slightly bend the lattice panel to form a curve in the line.
26. Trim the ends of the lattice ties.
If you have any questions regarding assembly please call our
customer service team on0117 9341790
