Edition 11.98
Power Hoe 6000
31
Dead Stop
Check the dead stop function each time
you maintain the machine.
l
The engine must automatically come
to a stop upon release of the lever (C/4)
and clutch engagement.
l
Inspect all electric lines and connec-
tions and replace them if necessary.
For this purpose contact your agria
workshop.
Drive-Wheel
l
Check the tyre pressure (1.2 bar) at
regular intervals.
l
Fit the wheels with pointed parts of
lugs showing in travelling direction
(wheels seen from above) to provide full
tractive power.
l
Retighten wheel nuts and locking bolts
at 100 Nm on the hubs each time you
maintain and service the machine.
5. Maintenance
Stop position
General
l
Watch out for fuel and oil leaks, and
remove them if necessary.
l
Check nuts and bolts regularly for tight
fit and tighten them if necessary.
l
Grease all gliding and moving parts
(e.g. speed control lever, hand lever
bearing, etc.) slightly with Bio-lubrication
grease and Bio-lubrication oil.
Cleaning
After each cleaning (washing with water,
especially with a pressure washer)
lubricate all lubrication points, oil the
machine, and let the power hoe run for a
short time to press the water out.
Apply grease generously and leave a
grease ring around the bearings to pre-
vent water, plant sap, and dirt from pen-
etrating.
Engine
Clean the engine only with a cloth. Avoid
spraying with strong jets of water be-
cause water might leak into ignition and
fuel system, causing malfunctions.
