20
Power Hoe 6000
Edition 11.98
3. Devices and Operating Elements
Attachment of
Hoeing Tools
W
Always shut off the engine
and remove the spark plug
connnector before you at-
tach/remove the hoeing tools. Wear
safety gloves.
l
Assemble the hoeing tools (A–C) us-
ing distancer sleeves (E–G) and guard
discs (D), if necessary, to obtain the
desired working width (see ”Combina-
tions of hoeing tools”, p21) and push them
on the shaft.
l
Insert the anchoring bolt (H) through
the tools and shaft.
l
Attach locking nut and tighten it at
100Nm.
Guard discs
The discs are to prevent shrubs and
bushes from being damaged by the hoe
and to protect young plants from being
covered with soil.
They also provide protection for the op-
erator when hoeing along headlands or
fences.
1
Front support wheel
2
Linch pin
3
Grip screw (clamping screw)
Front support wheel
(Accessory no. 0189 421)
For easier transport, use the front sup-
port wheel.
Installing the front support wheel
Push the square pin on the support wheel
(1) all the way in the rectangular tube and
connect both parts with a linch pin (2)
fitted through the borings.
To keep the front support wheel mounted
on the power hoe fold it up for hoeing.
Hoeing position
l
Loosen grip screw (3) until the notches
on the beam are released.
l
Fold the beam up into a mesh with the
notches and tighten the grip screw.
Transport position
l
Fold the support wheel down and
tighten the grip screw.
