7
IMPORTANT:
Make sure the tongue is securely locked to
the latch stand bracket by the latch lock lever.
21. Turn the cart over so that it rests right side up on its
wheels.
22. Assemble the end of the hitch bracket with two holes
down through the slot at the front of the drawbar tongue.
Fasten it to the tongue using the 3/8" x 1" hex bolt and
3/8" nylock nut.
Tighten.
See figure 13.
23. Assemble the hitch pin and 1/2" flat washer to the tongue
and hitch bracket and secure with the 3/32" hair cotter
pin. See figure 13.
FIGURE 13
24. Place the tailgate down into the tailgate guides so that
the holes in the bottom lip of tailgate fit over the slotted
head screws in the bottom of the cart.
3/8" x 1"
HEX BOLT
3/8" NYLOCK
NUT
HITCH
BRACKET
1/8" HAIR
COTTER
PIN
HITCH PIN
1/2" FLAT WASHER
COTTER
PIN
HUB CAP
FLAT
WASHER
FLAT
WASHER
AXLE
SHORT SPACER TUBE
WHEEL
20. Assemble a short spacer tube, a 1" flat washer, a wheel
(valve stem facing out), and another 1" flat washer onto
the axle. Secure with a cotter pin, spreading the ends
so that a hub cap can fit over the pin. Assemble the hub
cap by pressing it onto the flat washer. Fill wheel hub with
grease. Repeat on other end of axle. See figure 12.
IMPORTANT:
Pump grease into whel hub until grease is
forced out ends of hub.
FIGURE 12