5
FIGURE 5
12. Turn the latch stand bracket so that the aligning tab is
at the rear (bottom) of the bracket. Assemble the latch
stand bracket to the cart using four 1/4" x 3/4" hex bolts
and 1/4" nylock nuts.
TIGHTEN.
See figure 6.
FIGURE 6
11. Assemble the wheel support to the cart using eight 5/16"
x 3/4" truss head bolts and 5/16" nylock nuts as shown
in figure 5. Heads of bolts go on the inside of the cart.
Tighten.
FIGURE 4
FIGURE 7
13. Assemble the two corner caps to the front corners of
the cart using four 1/4" x 3/4" hex bolts and 1/4" nylock
nuts. Also assemble two 1/4" x 3/4" hex bolts and 1/4"
nylock nuts to the two rear corners of the cart.
Tighten.
See figure 7.
9. Assemble the front panel over the end of the cart using
six 1/4" x 3/4" hex bolts and 1/4" nylock nuts as shown
in figure 4. Leave two holes in the bottom of the panel
empty as shown. With the cart body halves pulled together,
tighten
the bolts in the bottom of the front panel, then
tighten
the bolts in the sides. See figure 4.
10. At this time
tighten
the bolts assembled in step 4, which
fasten the bottom of the cart together.
1/4" x 3/4"
HEX BOLTS
1/4" HEX NUT
1/4" HEX NUT
LEAVE HOLES OPEN FOR
LATCH STAND BRACKET
5/16"
NYLOCK
NUT
WHEEL
SUPPORT
5/16" x 3/4"
TRUSS HEAD BOLT
1/4" x 3/4"
HEX BOLT
LATCH STAND BRACKET
1/4" NYLOCK NUT
ALIGNING TAB
AT BOTTOM
CORNER CAP
1/4" x 3/4"
HEX BOLT
1/4" NYLOCK NUT
1/4" NYLOCK
NUT
