Agri-Fab LST 42A, Owner'S Manual

Page: 10 / 28

10
10. Assemble the short "V" belt onto the engine pulley
and then onto the large pulley on top of the clutch/idler
assembly. The belt must be placed to the inside of the
engine pulley keeper, the idler pulley and the keeper
bolt located beside the large pulley. See fi gure 14.
IMPORTANT: Do Not
assemble the "V" belt around the
outside of the engine pulley keeper or the keeper bolt.
Hold this drawing above you while viewing the
Clutch/Idler Assembly from underneath the
tractor. Right and left in the drawing will be the
reverse of the viewer's right and left.
FIGURE 15
FIGURE 14 VIEWED FROM UNDERNEATH
FIGURE 16
CABLE OPERATED ATTACHMENT CLUTCHES
1. Assemble the cable bracket to the clutch/idler assembly
using two 5/16" x 3/4" carriage bolts,
5/16" lock washers and 5/16" hex locknuts. Use the two
front holes in the cable bracket if your tractor has a 42"
mower deck. Use the two rear holes if your tractor has
a 46" mower deck. See fi gure 15.
2. Move the attachment clutch lever on the dash panel to
the disengaged (down) position.
3. Lay the clutch/idler assembly beneath the tractor.
4. Attach the tractor's clutch cable to the cable bracket.
Secure the cable housing guide (groove down) to the
cable bracket using the original collar and retainer spring
removed from the mower deck. See fi gure 16.
5. Place a spacer on the welded pin on the idler arm. Hook
the end of the clutch spring over the pin and secure it
with a 1/4" washer and a 5/64" hair cotter pin. See fi gure
16.
11. Proceed to page 13.
ENGINE
PULLEY
KEEPER BOLT
IDLER
PULLEY
ENGINE
PULLEY
KEEPER
Left Side
of Tractor
CABLE
BRACKET
5/16" x 3/4"
CARRIAGE BOLT
5/16" LOCK
WASHER
5/16" HEX
LOCK NUT
42"
DECKS
46"
DECKS
5/64" HAIR
COTTER PIN
SPACER
GROOVE
1/4" WASHER
TRACTOR'S
CLUTCH CABLE