8
STEP 8:
(SEE FIGURE 8)
•
Install a 1/2" x 2" hex bolt (B) and two 1/2" hex nuts
(W) in the outer hole in each side of the pivot plate.
Temporarily adjust the hex nuts so that both bolt
heads extend about an inch and a half above the
pivot plate.
STEP 10:
(SEE FIGURE 10 and 11)
•
Assemble the two angle lock bars together using a
3/8" x 1-1/4" carriage bolt (K) and a 3/8" nylock nut
(Q) in the top square holes.
Do not tighten.
•
Assemble the straight hook end of the extension
spring into the small holes in the angle lock bars.
Insert the lock bars down into the lock bar slot in
the channel pivot plate assembly.
STEP 9:
(SEE FIGURE 9)
•
Assemble the round hook end of the extension
spring into the hole in the washer
as shown.
FIGURE 8
FIGURE 9
FIGURE 10
FIGURE 11
WASHER
EXTENSION
SPRING
CHANNEL/PIVOT
PLATE ASSEMBLY
MOUNT
ROD
CHANNEL/PIVOT
PLATE ASSEMBLY
3/8" X 1-1/4"
CARRIAGE BOLT
(TOP HOLE) (K)
EXTENSION
SPRING
ANGLE LOCK
BARS
FRONT
LOCK BAR
SLOT
SPRING PIN
HOLE
3/8" NYLOCK
NUT (Q)
• Align the angle lock bars with the welded bracket on
the bottom of the channel. Use a hammer to drive
the 1/4" x 1" spring pin (NN) through the angle lock
bars and into the slot in the welded bracket.
•
Tighten
the nylock nut on the carriage bolt.
NOTE:
The angle lock bars should pivot freely. When
they are pulled all the way back the pivot plate assembly
should be unlocked and free to pivot to the right or left
notches.
FRONT
POSITION
NOTCH
1/4" X 1"
SPRING PIN (NN)
LOCK
BARS
ANGLE
LOCK BARS
1/2" X 2" BOLT (B)
1/2" HEX NUTS (W)
INSTRUCTIONS FOR ALL TRACTORS
