7
STEP 4:
(SEE FIGURE 4)
•
Place a 1/2" washer (EE) and then a short spacer (Y)
onto a 1/2" x 1-1/2" hex bolt (C). Install the bolt in the
bottom hole at the front of the R.H. side plate and secure
it with a 1/2" nylock nut (P). Repeat for the L.H. side
plate.
•
Skip to step 8
on page 8.
FIGURE 4
1/2" WASHER (EE)
1/2" X 1-1/2"
HEX BOLT (C)
1/2" NYLOCK
NUT (P)
SPACER
SHORT (Y)
REMOVE BOLTS
FROM THESE HOLES
FRONT
SUSPENSION
BRACKET
REMOVE NUT & WASHER
AND LEAVE BOLT (IF PRESENT)
3/8" NYLOCK NUT (Q)
(IF NEEDED)
3/8" x 1"
HEX BOLT (F)
3/8" LOCK
WASHER (Z)
REMOVE NUT & WASHER
AND LEAVE BOLT (IF PRESENT)
1/2" WASHER (EE)
1/2" X 1-1/2"
HEX BOLT (C)
1/2" NYLOCK
NUT (P)
SPACER,
SHORT (Y)
STEP 5:
(SEE FIGURE 5)
•
Remove bolts from holes shown in illustration if they
are present.
FIGURE 5
STEP 6:
(SEE FIGURE 6)
•
Fasten the R.H. side plate (bend facing out) to the two
holes indicated in the tractor frame. Use two 3/8" x 1"
hex bolts (F) and 3/8" lock washers (Z). If the bolts insert
loosely into the tractor frame, use two 3/8" nylock nuts
(Q) on the inside of the frame. Repeat for the L.H. side.
FIGURE 6
FIGURE 7
STEP 7:
(SEE FIGURE 7)
•
Place a 1/2" washer (EE) and then a short spacer (Y)
onto a 1/2" x 1-1/2" hex bolt (C). Install the bolt in the
bottom hole at the front of the R.H. side plate and secure
it with a 1/2" nylock nut (P). Repeat for the L.H. side
plate.
•
Go to step 8
on page 8.
INSTRUCTIONS FOR TRACTORS WITH DUAL
FRONT DECK SUSPENSION BRACKETS
