Agri-Fab 45-0298, Owner'S Manual

Page: 6 / 20

6
. Assemble two 3/8" x -/4" hex bolts, four /4" long
spacers, and two 3/8" nylock nuts to the holes on the
right side of the slot in the tray.
Tighten.
See figure 8.
2. Assemble the hitch bracket to the tongue using two 3/8"
x " hex bolts, and two 3/8" nylock nuts.
Tighten.
See
figure 8.
3. Assemble the hitch pin through the hitch bracket and
the tongue. Secure the hitch pin with the hair cotter pin.
See figure 8.
4. Turn the tray upside down. Place the ends of the shaft
through the holes in the end plates (end plates must
be loose). Make sure the middle wheel bracket is
approximately aligned with the slot in the tray. If it is not,
flip the shaft end for end. See figure 9.
15. Assemble a 3/4" flat washer and a wheel bracket onto
each end of the shaft. Secure each bracket with a /4"
x -3/4" hex bolt and /4" nylock nut. The wheel bracket
on each end must point toward the front while the middle
wheel bracket points toward the tray.
Tighten.
See figure
9.
NOTE:
Add extra 3/4" flat washers as shims if there is too
much end play in the shaft after assembly is completed.
FIGURE 10 UPSIDE DOwN VIEw
FIGURE 9 UPSIDE DOwN VIEw
16. Assemble a wheel to a wheel bracket as shown in figure
0. Use a /2" x 3-/2" hex bolt, one /2" hex jam nut,
and one /2" hex nylock jam nut. Adjust the nuts so that
the wheel is held securely but will spin freely. Repeat
on other side. See figure 10.
FIGURE 8
1/2" JAM NUT (M)
1/2" x 3-1/2"
HEX BOLT (A)
1/2" NYLOCK
JAM NUT (I)
3/8" NYLOCK
NUT (J)
3/8" x 1-1/4"
HEX BOLT (C)
1/4" LONG
SPACERS (P)
3/8" NYLOCK
NUT (J)
3/8" x 1"
HEX BOLT (D)
HAIR COTTER PIN (G)
HITCH
PIN (H)
3/4" FLAT
WASHER (O)
WHEEL
BRACKET
1/4" x 1-3/4"
HEX BOLT (B)
1/4" NYLOCK
NUT (L)
MIDDLE
WHEEL
BRACKET
ENGLISH