20
BE-TMSXXXX USER MANUAL
Adjustment of Mulcher working position
It is possible to work with the Mulcher both in a lateral and central position according to requirements. The
machine is already equipped with a mechanical lateral movement which can be replaced with a hydraulic
one on request. To adjust the position manually, remove the locking bolt, position the mulcher in the desired
position and lock it with the bolt removed at the start of the operation. If the mulcher is equipped with a jack
for lateral movement, once coupled to the tractor, connect the hydraulic tubes to the appropriate hitches
of the tractor’s hydraulic circuit. Using the appropriate lever, the movement of the desired mulcher can be
determined from the driving seat. In all cases, movement must be carried out horizontally on the working
plane with the mulcher slightly lifted off the ground.
BE-TMSxxxx
USAGE INSTRUCTIONS CONT.
4.2.3. Adjustment of Mulcher working position
It is possible to work with the Mulcher both in a lateral and central position according to requirements.
The machine is already equipped with a mechanical lateral movement which can be replaced with a hydraulic
one on request. To adjust the position manually, remove the locking bolt, position the mulcher in the desired
position and lock it with the bolt removed at the start of the operation. If the mulcher is equipped with a jack
for lateral movement, once coupled to the tractor, connect the hydraulic tubes to the appropriate hitches of
the tractor’s hydraulic circuit. Using the appropriate lever, the movement of the desired mulcher can be
determined from the driving seat. In all cases, movement must be carried out horizontally on the working
plane with the mulcher slightly lifted off the ground.
Model
HP Power
required
Movement (cm)
TMS 1400
60 - 70
90
60
50
80
TMS 1550
60 - 80
90
60
65
95
TMS 1850
60 - 80
90
60
95
125
TMS 2050
70 - 110
105
65
100
140
TMS 2300
90 - 110
105
65
125
165
After having familiarized yourself well with the controls, and having worn the PPE (personal protective
equipment) required, and having set the machine in the desired working position, and having connected the
multiplier and secured it properly to the tractor PTO by means of the cardan shaft, start the tractor engine,
disengage the parking brake, and engage the PTO while maintaining the engine at low rpm. Before starting
work, make sure that there are no exposed persons and/or animals near the machine.
Otherwise, have them move away. On start-up, move slowly with the tractor, gradually and slowly lower the
Mulcher until it reaches the ground. Then, the engine can be brought to the work speed. It is recommended
not to press the accelerator pedal rapidly when the tractor is stationary and the PTO is engaged and the
Mulcher is not running. This can cause damage to the machine and the tractor. The processed material is
shredded correctly by maintaining the tractor at a low forward speed and the rotor rotating at a regular
speed.
N.B: Braber recommends that you always use a tractor equipped with a closed booth.
DANGER
IT IS FORBIDDEN TO WORK WITH THE OPEN INSPECTION HOOD.
WARNING
The speed of the tractor with the Mulcher working must never exceed 5km/h in order to avoid breakage
or damage.
DANGER
During work, stones or other objects found in the terrain can be lifted and projected by the rotating
cutters. Constantly check that there are no persons or animals within the operating range of the Mulcher
(Fig. 12).
WARNING
Braber declines any and all liability for damages caused by the Mulcher to persons, animals or property,
resulting from use other than that described in this manual, or due to damage caused by negligence or
by not observing the instructions contained in this manual.
WARNING
Avoid letting the Mulcher rotate idly. During work, avoid making bends with the Mulcher lowered and do
not work in reverse. It is mandatory to always lift the Mulcher when changing direction or reversing the
drive.
