AGP EV160, Instruction Manual

Page: 7 / 24

7
UNPACKING
Carefully remove the tool and all loose items from the shipping container.
Retain all packing materials until after you have inspected and satisfactorily operated the
machine.
NOTE: An appropriate paddle must be mounted to the machine before operating.
Refer the section of this manual: “INSTALLING THE PADDLE”
CAUTION: Ensure that the paddle diameter does not exceed the machine’s maximum
rated capacity as listed on the machine nameplate and that the thread of
the coupling is correct.
CARTON CONTENTS
1. Mixing machine
2. Wrench (single paddle models only)
DO NOT OPERATE THIS TOOL UNTIL YOU READ AND UNDERSTAND THE ENTIRE
INSTRUCTION MANUAL.
INSTALLING THE PADDLE- DISCONNECT TOOL FROM POWER SOURCE.
Double paddle models only:
1. Pull outwards the knurled quick release collar (65) line up
the hex of the mixing paddle shaft and push the mixing
paddle fully home, then release the collar and pull the
paddle outwards slightly and the paddle will audibly snap in
place. See Fig.3.
2. Note that the two paddles are opposite twist and the left and
right side spindles are counter-rotating, so the mixing effect
will be different with the paddles on opposite sides (in one
orientation, the machine will tend to pull downwards, in the
opposite orientation, the machine will tend to push
upwards).
All other models:
Screw the mixing paddle (41) (optional) with thread M14 x 2 onto the spindle and tighten
with the open end wrench (40). See Fig.1.
Fig.3
Quick release
collars