8
Switching the machine on and off
To switch on:
Press the green ON button to start.
To switch off:
Press the red OFF button to stop.
After the machine has been switched off, the arbor
will still rotate for a time. Take care that parts of
your body do not come into contact with the
rotating parts or set the machine down while it is
still rotating!
Note: For your own safety!Always wear goggle
and take precautions before operating the
beveler. Make sure fully understanding and
compliance to the safety rules before use.
1. Press green ON button to start motor. Use the
handle to feed the machine to the desired
working angle to work. Always use very light
pressure when beginning the cutting.
2. To switch off the beveler, press the red motor
OFF button.
WARNING! Always switch off the beveler and
unplug the plug from the mains immediately
after use, in order to prevent being operated by
untrained personnel or accidents.
HOW TO USE THE TOOL
•
Effective control of this powerful tool requires
two-handed operation at all times for
maximum control and safety.
•
Do not use this tool continuously over 30
minutes.
•
Protect your eyes from injury with safety
glasses or goggles.
OPERATION
The machine must reach full speed before
beveling/deburring begins.
•
Hold the machine keeping the table plate flat
and securely to the workpiece. From the
operator ’s perspective, the spindle is
spinning clockwise, so always operate in the
direction from left to right (up mill).
•
When performing inside bevels, work in a
clockwise direction only.
•
Do not bevel too much per pass. If more
depth is needed, make multiple passes until
the desired bevel height is reached
MAINTENANCE
1.Keep tool clean
Pe r i o d i c a l l y b l o w t h e m a c h i n e w i t h d r y
compressed air. All plastic parts should be cleaned
with a soft damp cloth. NEVER use solvents to
clean plastic parts. They could possibly dissolve or
otherwise damage the material.
Wear safety glasses while using compressed air.
If the replacement of the power supply
cord is necessary, this has to be done by the
manufacturer or their agent in order to avoid a
safety hazard.
WARNING: All repairs must be entrusted to an
authorized service center. Incorrectly performed
repairs could lead to injury or death.
