5
SPECIFIC SAFETY RULES
1. Never operate the tool in an area with
flammable solids, liquids, or gases. Sparks
from the commutator/carbon brushes could
cause a fire or explosion.
Wa r n i n g : R i s k o f i n j u r y f ro m h i g h -
temperature chips!
High-temperature chips are expelled at
high speed.
Never touch the tool holder and keep all
vulnerable body parts clear while the
machine is running.
2. Always guide the machine away from the
body while working.
3. Do not work holding the machine above
your head.
WARNING! Some dust created by power
grinding contains chemicals known to
cause cancer, birth defects or other
reproductive harm.
An example of these chemicals are:
lead from lead-based paint
Your risk from these exposures varies,
depending on how often you do this type of
work. To reduce your exposure to these
chemicals: work in a well ventilated area, and
work with approved safety equipment, such
as those dust masks that are specifically
designed to filter out microscopic particles.
WARNING!: Never machine materials
which contain asbestos.
4. Use only recommended carbide inserts,
rated at the machine’s maximum rated
cutting rate or higher.
5. Do not use dull or damaged carbide inserts.
Dull inserts cause excessive friction and
binding and excessive load on the motor,
leading to possible damage.
6. I m p o r t a n t : A f t e r c o m p l e t i n g t h e
operation, Wait for coasting tool holder to
stop rotating completely before putting the
machine down.
7. Maintain labels and nameplates. These
carry important information. If unreadable or
missing, obtain a replacement.
F U N C T I O N A L D E S C R I P T I O N
INTENDED USE
This shape beveling and deburring tool is an
electrically driven portable machine:
For machining workpieces in steel, stainless steel,
chrome steel alloys, aluminum, aluminum alloys,
brass and plastic. The machine is designed
exclusively for Adding beveled edges, rounding off
edges, removing burrs , and removing sharp
corners on workpieces. The machine is equipped
with a graduated, depth and angle adjustable
table plate.
WA R N I N G : Th e m a c h i n e s h o u l d n o t b e
converted or modified, e.g. for any other form
of use, other than as specified in these
operating instructions.
The user shall be liable for damages and
accidents due to incorrect use.
ELECTRICAL CONNECTION
The network voltage must conform to the voltage
indicated on the tool name plate. Under no
circumstances should the tool be used when the
power supply cable is damaged. A damaged cable
must be replaced immediately by an authorized
Customer Service Center. Do not try to repair the
damaged cable yourself. The use of damaged
power cables can lead to an electric shock.
EXTENSION CABLE
If an extension cable is required, it must have a
sufficient cross-section so as to prevent an
excessive drop in voltage or overheating. An
excessive drop in voltage reduces the output and
can lead to failure of the motor. The following table
shows you the correct cable diameter as a function
of the cable length for this machine. Use only U.L.
and CSA listed extension cables. Never use two
extension cables together. Instead, use one long
one.
Total Extension
Cord Size (AWG)
Cord Length (feet)
25
16
50
12
100
10
150
8
200
6