6
matter.
16. Check the blade
for cracks or other damage before operation. Replace cracked or damaged blade
immediately.
17. Never start the tool
with the workpiece against the blade.
18. Allow the motor to achieve full speed
before cutting.
19. Important: After completing the cut,
release power switch and wait for coasting blade to stop completely
before putting the saw down.
20. Never operate
the tool in an area with flammable solids, liquids, or gases. Sparks from the commutator/
carbon brushes could cause a fire or explosion.
21. There are certain applications for which this tool was designed.
The manufacturer strongly recommends
that this tool NOT be modified and/or used for any application other than for which it was designed. If you
have any questions relative to its application DO NOT use the tool until you have written the manufacturer
and have been advised.
22. It is recommended that a residual current device of 30 mA sensitivity or less is used in the power supply
system
that this tool is to be plugged in to.
WARNING: Always wear hearing protection with this tool.
1. Intended use
This saw is designed exclusively for the sawing of wood, wood-like materials and plastics.
This machine should not be used for cutting other materials. The machine should not be converted or modified,
e.g. for any other form of use, other than as specified in these operating instructions. The user shall be liable for
damages and accidents due to incorrect use.
FUNCTIONAL DESCRIPTION
Arbor lock lever
Outer safety cover
Cutting depth scale
Cutting depth stop
Base
Thumb release carriage lock
On/Off
trigger switch
Main handle
Side handle
Hex allen wrench
Bevel lock knob
Fig.1
Rear zero degree
bevel adjustor
Front zero degree
bevel adjustor
Guide clearance adjustors
Dust extractor port
Plunge lock lever
