AGP AS200, Original Instructions Manual, Page: 5 / 46

5
WARNING: When anchoring to a brick surface, a special masonry anchor and brick fixing kit must be
used. Using a concrete type drop-in anchor in brick could lead to the brick cracking and the anchor
loosening!
NOTE: We recommend using the optional Anchoring Plate For Models S350, S500 & S800 for the most
secure possible fixing of the base to the workpiece. Place the anchoring plate on the base with the
threaded rod through the hole. Then add the washer and nut. Tighten securely.
Note: If mounting on a wall, it is usually more convenient to secure the stand with the motor head
removed. Using the 19mm combination wrench, loosen the cradle lock bolt on the carriage to lift the
motor head up and away. Once the stand is fixed, the motor head may be re-installed on the stand. Make
sure to securely tighten the cradle lock bolt(s).
ADJUSTING THE DRILLING ANGLE
The drilling angle can be tilted from 0 to 45 degrees. To adjust the angle, use
the crank handle as a wrench and loosen the angle clamp bolt. Refer to the
scale on the column indicating the angle. Adjust to the desired angle and
tighten the clamp.
CAUTION: Do not overtighten the clamp. Only tighten the necessary
amount to make the clamp secure. Overtightening could distort the
column.
AS200 folds down completely for easy storage
0 to 45 degrees
AS200 folds down
completely for easy
storage
S350, S500, S800
Fixing Kit
Anchoring Plate
Fixing Kit
AS200
Fixing Kit
Fixing Kit