13
BURNER COVER ASSEMBLY
Place the burner cover on the table top as shown in Figure 15.
WARNING: BEFORE PLACING THE BURNER COVER ON, MAKE
SURE THE FIREPIT HAS BEEN SHUT OFF AND THE BURNER HAS
COMPLETELY COOLED DOWN.
TROUBLESHOOTING GUIDE
PROBLEM
CAUSE
REMEDY
No Propane Gas at Burner
Check that gas tank valve is open. Turn
control knob to “ON” and push control knob
in. Make sure tank has propane gas.
No Spark at Electrode
Check that AA battery is installed with
negative (-) end first and has a charge.
Check that the wire is connected to the
ignition module. Check that the electrode is
not cracked or broken.
Burner won’t light
Lack of oxygen
Remove excess lava rocks or fire ice from
around the ignition well.
Thermocouple not in flame
Check that the tip of the thermocouple is
even with the top of the ignition well.
Remove any fire ice from the ignition well.
Thermocouple connection
at the main control valve is
loose
Tighten the thermocouple nut at the back of
the valve.
Burner won’t stay
lit after lighting
No Fire ice on Burner
Cover the burner with fire ice per the
instructions.
Our goods come with guarantees that cannot be excluded under the Australian Consumer
Law. You are entitled to a replacement or refund for a major failure and for compensation
for any other reasonably foreseeable loss or damage. You are also entitled to have the
goods repaired or replaced if the goods fail to be of acceptable quality and the failure does
not amount to a major failure.
Figure 15
Summary of Contents for 1900600
Page 40: ...40 ...
Page 49: ...4 A B C 9 J ...