12
5.3 Swapping Gimbals
When changing between modes 2/4 and 1/3 you will need to switch the gimbals around so that the throttle gimbal
is on the correct side.
2. Swap the gimbals and rotate them 180 degrees,
then line them up with the screw holes and
replace the screws.
(There is no need to
disconnect the cables.)
3. Replace the hand grips and insert batteries.
4. Turn on the transmitter and enter the servo
display screen to make sure everything is
working as expected.
1. Take the transmitter apart, using a Philips
screwdriver, remove the 8 screws marked in red.
2
3
4
