Agilent Technologies U1840A Medalist sj5000, Hardware Manual

Page: 133 / 192

Setting Up Barcode Readers
10
Agilent U1840A Medalist sj5000 Hardware Manual 10-17
number in the Device Manager (see “Checking the Serial
Port Number in Device Manager” ).
e
Exit the editor and restart the PC.
Checking the Serial Port Number in Device Manager
To find out the serial port number:
1
Make sure the barcode reader is connected.
2
Open the Device Manager by clicking
Start
>
Control Panel
>
System
>
Hardware
>
Device Manager
.
3
Look under Ports to find the USB-to-Serial port as shown
below.
Program the Barcode Reader
To program the barcode reader, refer to the Datalogic DLC7000
Series Manual . Then do the following:
• Scan the barcodes
Restore Defaults
,
RS232
, and
English
from the
manual with the reader. After each scan the reader should
emit two audible beeps.
• Next scan
Code 39
. When Code 39 is scanned the reader
should only beep once.