7
U1701A Quick Start Guide
Actions
Steps
To save comparison set for next entry
Press
and hold for more than 1 s
To exit compare mode
Press
To view the High/Low limit value to be used as compare
mode
Press
momentarily
To cycle through HI limit, LO limit, and present values on
the primary display
•
The secondary display showed as
H # #
,
L # #
and
C #
#
respectively.
•
After three seconds without pressing this button again, it
will return to the present value display.
Press
To toggle HI and LO limits for adjustment
Press
momentarily
To enter HI/LO limits setting mode
•
The secondary display will flash
H01
and the primary
display will indicate the value of HI limit.
•
The following buttons will be used for this setting mode:
a
To select which digit to be adjusted
b
To increase or decrease the current digit’s value
c
To select High or Low limit to be set.
d
To store the setting value in the memory. The beeper will
beep twice if the selected value has been stored. If the
current setting do not meet the rule that the high limit
must be equal or greater than the low limit, the beeper
will beep three times.
e
To select next compare setting. To cycle through L01 (or
H01) to L25 (or H25), then return to L01 (H01) setting.
Press
for more than 1 s
Press (Left)
or (Right)
Press (Up)
or (Down)
Press
Press
for more than 1 s
Press
momentarily
To exit the HI/LO limit setting mode
Press
for more than 1 s
To toggle backlight ON/OFF
•
Backlight turns off automatically after setting period by
setup mode.
Press
and hold for more than 1 s
