Agilent Technologies N9360A, Programming Manual

Page: 160 / 180

7-16 N9360A Multi UE Tester W-CDMA Programming Manual
7
Sample Program
Table 7-6 Program Comments
Row Description
2: Declares the variable to store test results.
4: Erases the status field.
7: Queries the manufacturer, model number, serial number and revision number of the firmware.
8-11: Displays the manufacturer, model number, serial number and revision number of the firmware on the status field.
13: Resets the Tester to the default setting for programming.
16: Activates the Loss correction function.
17: Sets the Loss RF IN field.
18: Sets the Loss RF OUT field.
19: Sets the Averaging.
20: Sets the Amplitude (BS Level).
21: Sets the 3GPP System.
24: Sets the Modulation to IDLE.
25: Sets the RF OUTPUT to ON.
29: Sets the Band and RFCH.
29: Starts the measurement.
30: Waits until the measurement is completed.
31: Queries the measurement result of TX Power.
32: Displays the measurement value and judgment result of TX Power in the status field.
33: Queries the measurement result of Frequency Error.
34: Displays the measurement value and judgment result of Frequency Error in the status field.
35: Queries the measurement result of EVM.
36: Displays the measurement value and judgment result of EVM in the status field.
37: Queries the measurement result of Origin Offset.
38: Displays the measurement value and judgment result of Origin Offset in the status field.
40: Displays Complete message in the status field.