Agilent Technologies N6700B, User Manual

Page: 121 / 206

Specifications Appendix A
Series N6700 User’s Guide 121
Supplemental Characteristics
Agilent Models N6751A/N6752A and N6761A/N6762A
N6751A / N6752A N6761A / N6762A
Programming Ranges:
Voltage high range 20 mV – 51 V 15 mV – 51 V
Voltage low range (
≤
5.5 V) N/A 12 mV – 5.5 V
Current high range 10 mA - 5.1A/10 mA- 10.2A 1 mA - 1.53 A/1 mA - 3.06 A
Current low range (
≤
0.1 A) N/A
0.1 mA – 0.1 A NOTE 1
Programming Resolution:
Voltage high range 3.5 mV 880
µ
V
Voltage low range (
≤
5.5 V) N/A 90
µ
V
Current high range 3.25 mA 60
µ
A
Current low range (
≤
0.1 A) N/A 2
µ
A
Measurement Resolution:
Voltage high range 1.8 mV 440
µ
V
Voltage low range (
≤
5.5 V) N/A 44
µ
V
Current high range 410
µ
A 30
µ
A
Current low range (
≤
0.1 A) N/A 1
µ
A
Programming Temperature Coefficient
per °C:
Voltage high range 18 ppm + 160
µ
V 18 ppm + 140
µ
V
Voltage low range (
≤
5.5 V) N/A 40 ppm + 70
µ
V
Current high range 100 ppm + 45
µ
A 33 ppm + 10
µ
A
Current low range (
≤
0.1 A) N/A 60 ppm + 1.5
µ
A
Measurement Temperature Coefficient
per °C:
Voltage high range 25 ppm + 35
µ
V 23 ppm + 40
µ
V
Voltage low range (
≤
5.5 V) N/A 30 ppm + 40
µ
V
Current high range 60 ppm + 3
µ
A 40 ppm + 0.3
µ
A
Current low range (
≤
0.1 A) N/A 50 ppm + 0.3
µ
A
Output Ripple and Noise (PARD):
CV peak-to-peak (typical value) 4 mV 4 mV
CC rms: 2 mA 2 mA
Common Mode Noise:
(from 20 Hz – 20 MHz; from either output to chassis)
rms 500
µ
A 500
µ
A
peak-to-peak < 2 mA < 2 mA
Over-voltage Protection:
Accuracy 0.25% + 250 mV 0.25% + 250 mV
Maximum setting 55 V 55 V
Response time 50
µ
s from occurrence of over-voltage
condition to start of output shutdown
1
If you are operating the unit below 255
µ
A in constant current mode, the output may
become unregulated with the following load conditions: The load resistance is <175 m Ω and
the load inductance is >20
µ
H. If this occurs, an UNRegulated flag will be generated and the
output current may rise above the programmed value but will remain less than 255
µ
A.