Agilent Technologies N4413A, User Manual

Page: 22 / 234

User Interface
The Main Screen
Chapter 2 12
The Indicator Bar
The Indicator Bar buttons show measurements settings.
• Green buttons show settings that will affect future measurements.
• Blue buttons show settings applied to the current data.
De-embedding Indicators
See “Setup > Modify Rotations…” on page 119 .
4 The system displays messages at the bottom of the screen in the Message Window .
5 If Measure Count is enabled, it shows the number of measurements made. See
“Utility > Measurement Counter Visible” on page 151 .
6 Measure starts the measurement sequence. See “How to Make Measurements” on
page 47 .
7 Continuous Sweep performs the next measurement with continuous sweeps.
Click the STOP button to stop continuous measurements.
NOTE: If Continuous Sweep is enabled, Measure Count does not increment.
8 Use the DEVICE: and SN: boxes to the right to enter information about the device
under test. This information is saved with the DUT data set and appears in printouts
and exported data files.
9 The Indicator Bar shows the measurement settings. See “The Indicator Bar” on
page 12 .
10 Port Impedance , as defined through the setup, is shown in this area unless all ports
are set to 50
Ω
.
De-embedding or reference plane rotation has been activated in Setup.
The data has been modified by de-embedding or reference plane rotation.