Agilent Technologies InfiniiVision 3000 X-Series, Programmer'S Manual

Page: 5 / 1232

Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 5
• Chapter 24 , “:RECall Commands,” starting on page 565, describes
commands that recall previously saved oscilloscope setups, reference
waveforms, or masks.
• Chapter 25 , “:SAVE Commands,” starting on page 573, describes
commands that save oscilloscope setups, screen images, and data.
• Chapter 26 , “:SBUS<n> Commands,” starting on page 595, describes
commands that control oscilloscope functions associated with the serial
decode bus and serial triggering.
• Chapter 27 , “:SEARch Commands,” starting on page 743, describes
commands that control oscilloscope functions associated with searching
for waveform events.
• Chapter 28 , “:SYSTem Commands,” starting on page 817, describes
commands that control basic system functions of the oscilloscope.
• Chapter 29 , “:TIMebase Commands,” starting on page 831, describes
commands that control all horizontal sweep functions.
• Chapter 30 , “:TRIGger Commands,” starting on page 843, describes
commands that control the trigger modes and parameters for each
trigger type.
• Chapter 31 , “:WAVeform Commands,” starting on page 923, describes
commands that provide access to waveform data.
• Chapter 32 , “:WGEN Commands,” starting on page 959, describes
commands that control waveform generator (Option WGN) functions and
parameters.
• Chapter 33 , “:WMEMory<r> Commands,” starting on page 985, describes
commands that control reference waveforms.
• Chapter 34 , “Obsolete and Discontinued Commands,” starting on page
995, describes obsolete commands which still work but have been
replaced by newer commands and discontinued commands which are no
longer supported.
• Chapter 35 , “Error Messages,” starting on page 1047, lists the
instrument error messages that can occur while programming the
oscilloscope.
The command descriptions in this reference show upper and lowercase
characters. For example, :AUToscale indicates that the entire command
name is :AUTOSCALE. The short form, :AUT, is also accepted by the
oscilloscope.
Then, there are chapters that describe programming topics and conceptual
information in more detail:
• Chapter 36 , “Status Reporting,” starting on page 1055, describes the
oscilloscope's status registers and how to check the status of the
instrument.
• Chapter 37 , “Synchronizing Acquisitions,” starting on page 1077,
describes how to wait for acquisitions to complete before querying