Agilent Technologies InfiniiVision 3000 X-Series, Programmer'S Manual

Page: 595 / 1232

s 1
595
Agilent InfiniiVision 3000 X-Series Oscilloscopes
Programmer's Guide
26
:SBUS<n> Commands
Control the modes and parameters for each serial bus decode/trigger type.
See:
• "Introduction to :SBUS<n> Commands" on page 595
• "General :SBUS<n> Commands" on page 597
• ":SBUS<n>:A429 Commands" on page 600
• ":SBUS<n>:CAN Commands" on page 618
• ":SBUS<n>:FLEXray Commands" on page 635
• ":SBUS<n>:I2S Commands" on page 654
• ":SBUS<n>:IIC Commands" on page 673
• ":SBUS<n>:LIN Commands" on page 683
• ":SBUS<n>:M1553 Commands" on page 697
• ":SBUS<n>:SPI Commands" on page 704
• ":SBUS<n>:UART Commands" on page 721
Introduction to
:SBUS<n>
Commands
The :SBUS subsystem commands control the serial decode bus viewing,
mode, and other options.
The following serial bus decode/trigger types are available (see
":TRIGger:MODE" on page 851).
• CAN (Controller Area Network) triggering — will trigger on CAN
version 2.0A and 2.0B signals. Setup consists of connecting the
oscilloscope to a CAN signal. Baud rate, signal source, and signal
polarity, and type of data to trigger on can be specified. You can trigger
on CAN data and identifier patterns and you can set the bit sample
point.
• I2S (Inter- IC Sound or Integrated Interchip Sound bus) triggering —
consists of connecting the oscilloscope to the serial clock, word select,
and serial data lines, then triggering on a data value.
N O T E
These commands are only valid on oscilloscope models when a serial decode option has
been licensed.