Agilent Technologies 83433A, User Manual

Page: 27 / 62

2-8
Using the Agilent 83433A
Performing a Quick Confidence Check
If the verification check fails
If the lightwave transmitter does not pass the verification check, you should
review the procedure being performed when the problem occurred. A few
minutes spent performing some simple checks may save waiting for your
instrument to be repaired. Before calling Agilent Technologies or returning
the unit for service, please make the following checks:
1 Is the line fuse good?
2 Does the line socket have power?
3 Is the unit plugged in to the proper ac power source?
4 Is the unit turned on? Verify the green light-emitting diode (LED) next to the
line switch is on, indicating that the power supply is on.
5 If other equipment, cables, and connectors are being used with the lightwave
transmitter, are they connected properly and operating correctly?
6 Review the procedure for the test being performed when the problem
appeared. Are all the settings correct?
7 Are the connectors clean? Refer to “Cleaning Connectors” on page 3-12 for
more information about cleaning the connectors.
If the lightwave transmitter still fails, you can:
Return the lightwave transmitter to Agilent Technologies for repair. If the
lightwave transmitter is still under warranty or is covered by an Agilent Tech-
nologies maintenance contract, it will be repaired under the terms of the war-
ranty or contract (the warranty is at the front of this manual). If the lightwave
transmitter is no longer under warranty or is not covered by an Agilent Tech-
nologies maintenance plan, Agilent Technologies will notify you of the cost of
the repair after examining the unit. Refer to
“Returning the Instrument for
Service” on page 3-16 for more information.
W A R N I N G
No operator serviceable parts inside. Refer servicing to qualified
personnel. To prevent electrical shock do not remove covers.