LO to Chassis Leakage
1.
Make Hardware Connections
•
Turn power supply and mainframe power OFF
•
Connect DMM, power supply, and resistor as shown in
Figure 2-10
•
Turn power supply and mainframe power ON
2.
Check Direct Terminals Leakage Current
•
Send *RST to FET Multiplexer
•
Send TRIG SGL to DMM
•
Record the DMM reading in Table 2-1
Positive Polarity, LO to Chassis, Direct
•
The DMM measurement should be less than 0.010 Vdc.
A measurement out of this range indicates a failure of the
FET Multiplexer.
3.
Check Channels Leakage
•
Send CLOS(@
nn
00) to the FET Multiplexer, where
nn
is the
card number (typically 01)
•
Send TRIG SGL to DMM
Agilent E1300B/E1301B
Figure 2-10. Positive LO to Chassis Leakage Connections
Verification Tests 2-17
Summary of Contents for 75000 SERIES B
