8210-00023 R0
11
2.11. Positioning the Auger
• Transport and place equipment on reasonably level ground when raising, lowering,
positioning, or operating.
• Move the auger into position slowly. Do not unhitch and attempt to move by hand.
• Chock wheels and anchor intake end after placement.
2.12. Towing the Auger
The auger is not intended for transport on public roads. If it requires transport on a public roadway, the
following steps should be taken:
• Check with local authorities regarding transport on public roads. Obey all applicable laws
and regulations.
• Always travel at a safe speed, never exceeding 20 mph (32 km/h).
• Reduce speed on rough surfaces.
• Do not transport on slopes greater than 20°.
• Use caution when turning corners or meeting traffic.
• Make sure the SMV (slow moving vehicle) emblem and all the lights and reflectors that are
required by local authorities are in place, are clean, and can be seen by all over-taking and
oncoming traffic.
• Always use hazard-warning flashers on tractor/towing vehicle when transporting unless
prohibited by law.
• Do not allow riders on the auger or towing vehicle during transport.
• Attach to towing vehicle with an appropriate pin and retainer. Always attach safety chains.
• Place the auger in the transport position before moving on roads.
2.13. Drives and Lockout Safety
Inspect the power source(s) before using and know how to shut down in an emergency.
Whenever you service or adjust your equipment, make sure you shut down the power
source and unplug or remove the key (as applicable) to prevent inadvertent start-up and
hazardous energy release. Know the procedure(s) that applies to your equipment from the
following power source(s). Ensure that all personnel are clear before turning on power to
equipment.
6300 SERIES – PORTABLE GRAIN AUGER
