AGI A296, Installation Instructions

Page: 1 / 4

30940 R5
Revised: APRIL 2019
1
A296/A266
Hydraulic Winch Kit
Installation Instructions
Applicable Models:
MKX100, MKX130, X100, X130, HX100, & HX130 Series
Pre-Installation Instructions
• Familiarize yourself with all the required hardware. Kit A296 is for MKX100, X100 and HX100 augers. Kit
A266 is for MKX130, X130, and HX130 augers.
• Arrange all parts for easy access.
Hydraulic Winch Installation
1. Unwind the cable from the manual winch spool and disconnect the cable from the spool by loosening or
removing the cable clamp and pulling the cable free of the spool.
2. Disconnect the manual winch from the auger boot.
3. Install the hydraulic winch (see Figure 1 on page 2 or Figure 2 on page 2 ).
4. For 100 series: Install the pulley guide onto the lift arm (see Figure 1 on page 2 ).
Note
The pulley guide for the 130 series is factory pre-assembled onto the lift arm.
5. Ensure that the winch cable feeds through the two lift arm pulleys (at the top of the lift arm and at the
pulley guide), then feed the winch cable under the spool and connect it to the spool (minimum 3 wraps
around the spool, feed cable through hole in side of spool, and secure with clamp and clamp hardware) as
shown in
Figure 3 on page 3 .