U - 20
User Guide
CLIP - display caller’s phone number
h
*254
q
ª
Lift
receiver
Clip
Acknowledgement
ton
Replace
reciever
2
3
off
on
Switching on CLIP
Notes
Your complete number will be send to the network consisting of STD Code and DDI number
or STD Code and MSN number, depending if the line is for system access (PTP) or standard
access (PTMP). You must transmit a valid number belonging to you. If you transmit a number
which is outside your allocated range then the telephone exchange will automatically replace
this number with the main number allocated to the ISDN 2 e circuit.
Call charges cannot be billed by Network provider under seperate MSN numbers
Therefore change to the following. To transmit a specific MSN number back to the exchange
dial the following without "0" :
*676
- MSN -
#
- external number.
h
*794
q
ª
Lift receiver
Clip
Replace
receiver
Acknowledgement
tone
off
on
2
3
Setting CLIP to on / off
On analogue telephones which support the CLIP feature, you will see who is calling before
you lift the receiver. For external calls, the caller’s number and the date/time are
displayed. The name is displayed additionally for internal calls.
You have to set whether or not you want to use the CLIP function on the telephone.
Programming mode must be started by entering :
h
P
*PRO
Q
ª
Continue programming or end programming mode by entering:
h
P
*END
Q
ª
Summary of Contents for AC 14
