AGFEO AC 14 USB, Manual

Page: 9 / 76

S - 3 Set up
S
Wall mounting
- Mark two vertical drill holes 125 mm apart on
the wall.
- When marking the drill holes, make sure that
there are no concealed lines at these points
(gas, water pipes, electric cables or similar).
- Drill the two holes.
- Mark two vertical drill holes 125 mm apart on
the wall.
- When marking the drill holes, make sure that
there are no concealed lines at these points
(gas, water pipes, electric cables or similar).
- Drill the two holes.
- Hammer in the plugs flush with the wall.
- Screw in the two screws leaving the head
protruding by about 4 mm.
- Hang the telecommunications system on the
screws and pull it down on the wall until it
snaps into place.
Ready to start in seconds
- Plug the Western plug of the power pack into
the socket marked "Power" until it snaps in
audibly
- Plug one of the Western plugs of the ISDN
connecting cable into the socket marked "S0"
until it snaps in audibly
- Plug the other Western plug of the ISDN
connecting cable into the NTBA (NT) or an
installed ISDN socket
- Plug the Western plugs of your terminal into
the Western sockets of the telecommunications
system
In the
as-delivered state , the connections 1
and 2 are set to telephone, connection 3 to
answering machine and connection 4 to combi-
port, e.g. for fax.
- Plug the power pack into a 230 V socket. The
green LED lights up.
- You can now use the phone. After lifting the
handset you will hear the external dialling tone
and can call any external subscriber.
- The internal phone numbers 11, 12 and 13 are
called when one of your phone numbers (MSN)
is called.
To enter your multiple subscriber numbers
(MSN’s), change the ringing assignment and set
other functions, please read the chapter
"Programming".
Quick entry of multiple subscriber numbers
You can enter multiple subscriber numbers
(MSN’s) under which you can be reached in the
telecommunications system uncomplicatedly and
quickly. Enter the MSN with this function at every
connection and the corresponding terminal is
entered in the ringing assignment for this MSN. Example: Enter your phone number (345678) at
connections 1, 2 and 3. At connection 4 the
number of your fax (345677). Callers then reach
your telephones and answering machine when
they call 345678. The fax is reached under 345677.
See the “Programming Instructions” for further
information.
Lift
handset MSN quick s ss s save
h * M S N S M z # q ª
Replace
handset Acknowledgement
tone
Start programming mode:
h
*PRO
q
ª
Exit programming mode:
h
*END
q
ª
(system -PIN)
PRO
END
Enter multiple
subscriber
number (MSN) M
SN-
ID