AGFA Avantra 36/44, Service Manual, Page: 515 / 521

Section V: Crane
Removal and Replacement 2-13
11. Remove the E-clip from the guiding bar and slide the bar out. Figure 1-9.
12. By hand, turn the drive coupler clockwise to unwind the cable. Figure 1-9.
13. Using a 5/32" hex wrench, remove the screw from the cable guiding block.
Figure 1-9.
Figure 2-9 Cable drum with guiding bar and block.
➀
–Cable drum.
➁
–Slack safety switch wires.
➂
–Two phillips screws for safety switch.
➃
–Slack safety switch .
➄
–Guiding bar.
➅
–Guiding block.
➆
–One 5/32
"
hex screw.
14. Continue to turn the drive coupler clockwise until the set screw is visible in
the drum. Figure 1-10. Use a 1/16" allen wrench to loosen the set screw.
4
1
6
2
7
3
5