AGFA ADC Solo, User Manual

Page: 15 / 70

15
2301D EN 20040224
The display
The ADC Solo control panel has a backlit LCD display with 8 lines of 40 charac-
ters each. Its lay-out depends on the operating mode.
◆
In operator mode, the display has dedicated areas for specific information:
1 Set-up of image processing station:
• [blank]: Default image processing station selected.
• Off line: Transmission to all image processing stations disabled.
• [process.station] not ready: Image processing station not available.
• [process.station] rerouted: Images rerouted to other image processing sta-
tion.
2 Type of message
3 Extra comment or action to take
4 System status:
• READY: The ADC Solo is ready for operation.
• BUSY: The ADC Solo is treating an image plate.
• ERROR: An error has occurred. Refer to ‘Troubleshooting checklist’ on
page 50 .
• LOCKED: id.
• WARNING: id.
5 Operation mode:
• [blank]: Normal operation mode.
• EMERGENCY: Emergency function for image plates with ID data.
• EMERGENCY BUTTON: Emergency function for image plates without
ID data.
• ERASURE: Re-erasure function.
• DIRECT ID: Operation in dedicated configuration.
6 Error status: service code (SERVICE XXXXX) or error code (CODE XXXXX)
3
1
Set-up STATUS
OPERATION MODE
1ST MESSAGE
2nd Message
Patient_Last_Name Sub_Exam
Patient_Last_Name Sub_Exam
Patient_Last_Name Sub_Exam
Station Name
ERROR
5
6
8.1
8.2
8.3
1
2 4
7